On the front and back sides, peel off the excess skin sticker from the backing paper. Next, peel off the skin sticker from the main unit and place it upside down. Remove the Apple logo part by pushing it out, and then shift the backing paper and reattach it from the top as shown in the figure below. Please note that it is not possible to remove only the Apple logo part after it has been applied to the device.

Align with the orange areas and affix. There are some margins on the top, bottom, left and right to prevent peeling. Next, peel off the backing paper, apply the entire skin sticker, and then firmly rub the skin sticker to press it into place. Avoid aligning the skin seal with the Apple logo, as this will result in misalignment. Also, when you peel off the skin seal to reattach it before crimping, be careful of the direction you peel off the skin seal, as it may tear from the edge of the Apple logo.

Align and stick the rubber foot on the hinge side. Next, peel off the backing paper and apply the entire skin seal, then firmly rub and crimp the skin seal.

<In case of using MacBook Pro 16-inch (2021~), MacBook Pro 14-inch (2021~), MacBook Air 13-inch (2022~)

Keep the skin seal floating around the bottom when attaching the bottom, warm the skin seal firmly with warm air from a hair dryer, and when the skin seal becomes soft enough, rub and crimp the skin seal. If the skin seal is not sufficiently warmed up, it may float.

<In case of MacBook Pro 13-inch (2009-2011) and (2012-2015)

Keep the four corners of the seal floating and warm the skin firmly with warm air from a hair dryer, and when the skin seal becomes soft enough, apply in the order from ① to ③.

Attach the palm rest portion by pulling it over the left and right outer corners (orange areas).

<以下の機種をご利用の場合>

MacBook Air 15-inch (2023〜)

-

トラックパッド部分を先に貼り付けます。その後、スキンシールを剥がして平らなところに裏返しに置き、図のとおり台紙をずらして上から貼り直してから、キーボード奥側から合わせて貼り付けます。全て貼り終えたあとにキーボード部分のスキンシールを取り除きます。（※トラックパッドは感度が低下しますのでお好みに応じてお使いください。）

MacBook Pro 13-inch (2020) and (2016-2019) only, side skin stickers are included. Please apply in the order of (1) to (4) in the figure on the right. Please note that the skin sticker will stretch if you pull it.

<In case of MacBook Pro 13-inch (2020)

For models with four USB-C ports, please remove the skin stickers from the USB-C port on the right side (orange part) and the exhaust ports on the left and right sides of the bottom.

-MacBook Pro 13-inch (13-inch) and MacBook Pro 13-inch (13-inch)

<For MacBook Pro 13-inch (2016-2019)

For models without TouchBar, please move a part of the skin sticker (pink part) to the position surrounded by the dotted line.